Product Overview
The Vertical Electric Sheep Skin Puller uses a motor‑driven stainless roller to remove the main hide from a suspended sheep or goat carcass. Its upright format occupies little floor width and suits lower‑capacity lines that want a powered pull without a separate hydraulic power pack. Variable roller speed allows the operator to slow the movement for difficult hides and increase it when preparation is consistent.
The reference unit is rated at 1.5 kW with a pulling‑speed range of 1.6–16 m/min and a stated maximum of 100 sheep per hour. Galvanized or stainless framing is offered. The source also lists a 6 MPa working pressure even though the product is described as electric; the circuit associated with that pressure is not identified. This value must be clarified rather than copied into a final purchase specification as a confirmed utility.
Working Principle
Operators open the hide around the legs and free enough material for secure attachment to the pulling roller or chain. The electric drive rotates the roller and draws the hide downward or along the configured vertical path while the carcass stays on the rail. Speed is adjusted to suit carcass condition and operator trimming. Once the hide has separated, it is released to a collection point and the roller reverses or resets. Guards and an emergency stop should remain within easy reach throughout the cycle.
Main Features
Vertical layout for a narrow dehiding station
1.5 kW electric roller drive
Variable pulling speed from 1.6 to 16 m/min
Stainless pulling roller
Galvanized or stainless main‑frame options
Maximum stated output of 100 sheep per hour
Technical Specifications
Reference configuration from the source listing. Confirm final utilities, materials, interfaces and performance in the supplier quotation.
| PARAMETER | REFERENCE SPECIFICATION |
| Reference model | HT‑C207‑III |
| Operating type | Electric skin puller |
| Electrical supply | 380 V / 50 Hz / 3 phase |
| Installed power | 1.5 kW |
| Pulling speed | 1.6–16 m/min |
| Maximum stated capacity | 100 sheep/hour |
| Main frame | Galvanized steel or stainless steel |
| Pulling roller | Stainless steel |
| Listed working pressure | 6 MPa — circuit not identified; supplier clarification required |
| Overall dimensions / rail interface | Not stated; project‑specific |
Application
The puller is appropriate for low‑ to medium‑output sheep and goat abattoirs, mobile or compact plants, and retrofit projects where a narrow vertical station is available. It should be paired with manual pre‑skinning, a stable carcass rail and a defined hide collection route. The buyer must confirm pulling direction, roller attachment, speed control, electrical enclosure, guard arrangement and whether any hydraulic circuit is actually part of the offered model.
Reference Application Case
Reference application: a 70‑head‑per‑hour multi‑species abattoir installs the electric puller beside an existing sheep rail Operators use the lower part of the speed range for heavy woolled animals and increase speed only after a clean pre‑skinning cut. Hides drop into a wheeled bin below a guarded discharge. Before commissioning, the supplier confirms in writing that the quoted unit needs only electrical power—or identifies the purpose and components of the listed 6 MPa circuit. The example shows the due‑diligence step needed for this source data.
Advantages
1. Lower installed power than the listed hydraulic puller
2. Variable speed gives the operator useful control over the pull
3. Narrow vertical arrangement can fit constrained retrofit spaces
4. No dedicated hydraulic power pack is indicated in the basic description
5. Stainless roller is suited to repeated cleaning and hide contact
