Pig Carcass Electric Scalding Tank

This Pig Carcass Electric Scalding Tank is specified for one practical job: a heated‑water system that conditions pig skin, heads or hooves before mechanical hair removal. A reliable installation begins with correct interface dimensions and a realistic duty cycle. The HT listing supplies reference data for the offered arrangement; those figures are reproduced below for comparison. For export quotations, confirm voltage, materials, guarding, spare parts and documentation before the purchase order is released.

Product Overview

Working Principle

Product is immersed, sprayed or conveyed through controlled hot water for a set time. Temperature and exposure loosen hair without unnecessary heat damage, after which the item moves directly to the dehairing step. The upstream machine must not feed faster than the receiving station can clear.

Main Features

Stable scalding temperature
Exposure time matched to the product
Insulated tank or enclosure options
Controlled overflow and drainage
Safe loading and discharge
Access for sediment removal

Technical Specifications

Parameter	Reference Value / Buyer Check
Model	HT‑P201‑I
Application	Which main used to scald pig carcass for dehairing
Working principle	electric
Rated voltage / phase / frequency	380v / 3p / 50hz
Power	30Kw
Scalding temperature	58‑62℃
Out size	30002000800mm(LWH)
Component and material	1) Stainless steel square steel main frame 2) 80mm polyurethane insulation layer 3) 2mm 304 Stainless steel plate shell 4) 30kw stainless steel electric heating rod 5) Drain valve 6) Temperature control system
Quotation control	Confirm product size, batch or continuous duty, capacity, target temperature, heat source, water volume, make‑up rate, exhaust and effluent arrangements.

Reference configuration transcribed and normalized from the cited HT product page; confirm the final quotation and approved drawing.

Application

The usual application is pig carcass, head and hoof preparation lines ahead of dehairing or finishing. It can be specified for a new line or adapted to a retrofit, provided that the existing supports, working heights, utilities and control signals are measured on site. Plants handling several pig sizes should state the full range rather than quoting only an average.

Application Case

Illustrative reference case-A regional pork processor planning for 200 pigs per hour places the pig carcass electric scalding tank between the relevant upstream and downstream stations. Before fabrication, the project team freezes the interface drawing, utility points and operator access. The acceptance check covers dry running, representative‑load operation, emergency stops, cleaning access and a spare‑parts handover.

Advantages

1. Fits into a defined process stage, which makes line balancing and internal linking easier.
2. Project‑specific dimensions reduce awkward field modifications at installation.
3. Service points and replaceable wear parts can be agreed before shipment.
4. Hygiene and drainage requirements can be reviewed with the equipment layout.
5. Reference source data remains visible instead of being converted into unsupported marketing claims.

Pig Carcass Electric Scalding Tank FAQ

What information is needed to quote the Pig Carcass Electric Scalding Tank?

Confirm product size, batch or continuous duty, capacity, target temperature, heat source, water volume, make-up rate, exhaust and effluent arrangements.

Can it be connected to an existing slaughter line?

Usually yes, but a retrofit needs measured drawings. Share the rail or conveyor interface, floor levels, travel direction, available space, utilities and current control method before engineering starts.

Which spare parts should be ordered with the machine?

Start with the normal wear and hygiene parts for this duty: bearings, seals, sensors, chains or belts, nozzles, blades, scrapers, pneumatic parts and electrical protection devices as applicable. The supplier should issue a model-specific list.

Are the published technical figures final?

No. The table records reference information from the citedHTpage. Capacity, power, dimensions, material grade and utilities must be confirmed on the quotation and approved drawing.

How should the equipment be accepted after installation?

Use a documented site-acceptance test covering alignment, guards, emergency stops, interlocks, dry running, representative load, cleaning access, leakage or drainage, operator training and delivery of manuals and spares.