Pig Bleeding Chain for Pig Slaughtering Line

This Pig Bleeding Chain for Pig Slaughtering Line is specified for one practical job: a load‑bearing chain, shackle, hook or trolley component for overhead pig and carcass handling. A reliable installation begins with correct interface dimensions and a realistic duty cycle. The HT listing supplies reference data for the offered arrangement; those figures are reproduced below for comparison. For export quotations, confirm voltage, materials, guarding, spare parts and documentation before the purchase order is released.

Product Overview

Working Principle

The carrier takes the animal or carcass load and travels along the specified rail or chain path. Wheels, pivots and contact points guide the load while allowing transfer, return and cleaning between cycles. The upstream machine must not feed faster than the receiving station can clear.

Main Features

Load rating matched to carcass weight
Geometry compatible with the rail
Wear parts that can be replaced
Smooth surfaces for cleaning
Controlled spacing on powered lines
Traceable spare‑part dimensions

Technical Specifications

Parameter	Reference Value / Buyer Check
Model	HT‑P111‑II
Application	Which main used to hang pig carcass for bleeding
Max load‑bearing	500kg
Material	Stainless steel
Length	0.6‑0.96mm
Quotation control	Provide rail profile, wheel diameter, axle dimensions, hook or shackle drawing, rated load and chain pitch. Small dimensional differences can prevent interchangeability.

Reference configuration transcribed and normalized from the cited HT product page; confirm the final quotation and approved drawing.

Application

The usual application is bleeding rails, dressing lines, chill rooms and empty‑carrier return systems. It can be specified for a new line or adapted to a retrofit, provided that the existing supports, working heights, utilities and control signals are measured on site. Plants handling several pig sizes should state the full range rather than quoting only an average.

Application Case

Illustrative reference case-A regional pork processor planning for 200 pigs per hour places the pig bleeding chain for pig slaughtering line between the relevant upstream and downstream stations. Before fabrication, the project team freezes the interface drawing, utility points and operator access. The acceptance check covers dry running, representative‑load operation, emergency stops, cleaning access and a spare‑parts handover.

Advantages

1. Fits into a defined process stage, which makes line balancing and internal linking easier.
2. Project‑specific dimensions reduce awkward field modifications at installation.
3. Service points and replaceable wear parts can be agreed before shipment.
4. Hygiene and drainage requirements can be reviewed with the equipment layout.
5. Reference source data remains visible instead of being converted into unsupported marketing claims.

Pig Bleeding Chain for Pig Slaughtering Line FAQ

What information is needed to quote the Pig Bleeding Chain for Pig Slaughtering Line?

Provide rail profile, wheel diameter, axle dimensions, hook or shackle drawing, rated load and chain pitch. Small dimensional differences can prevent interchangeability.

Can it be connected to an existing slaughter line?

Usually yes, but a retrofit needs measured drawings. Share the rail or conveyor interface, floor levels, travel direction, available space, utilities and current control method before engineering starts.

Which spare parts should be ordered with the machine?

Start with the normal wear and hygiene parts for this duty: bearings, seals, sensors, chains or belts, nozzles, blades, scrapers, pneumatic parts and electrical protection devices as applicable. The supplier should issue a model-specific list.

Are the published technical figures final?

No. The table records reference information from the citedHTpage. Capacity, power, dimensions, material grade and utilities must be confirmed on the quotation and approved drawing.

How should the equipment be accepted after installation?

Use a documented site-acceptance test covering alignment, guards, emergency stops, interlocks, dry running, representative load, cleaning access, leakage or drainage, operator training and delivery of manuals and spares.