Pig Abattoir Working Platform

For line designers, the Pig Abattoir Working Platform provides a stable receiving or working surface for a manual operation, inspection step or short transfer. Its value depends on the hand‑off before and after the machine, so the rail, floor level and controls should be reviewed together. The HT listing supplies reference data for the offered arrangement; those figures are reproduced below for comparison. For export quotations, confirm voltage, materials, guarding, spare parts and documentation before the purchase order is released.

Product Overview

Working Principle

The frame supports a table, roller bed, grate or adjustable platform at the required height. Product is received, held or moved onward by an operator, gravity or a small drive, depending on the configuration. Cleaning access and safe isolation are part of the operating principle, not optional extras.

Main Features

Working height suited to the task
Drainable, easy‑clean surfaces
Safe access and handrails where needed
Alignment with the rail or conveyor
Adjustable feet or anchored installation
Space for tools and sterilizers

Technical Specifications

Parameter	Reference Value / Buyer Check
Model	HT‑P305
Application	Which main used to assist staffs convenient to skinning pig
Out size	2000600200mm (LWH)
Component and material	1) ∮159mm hot galvanized steel or stainless steel pipe support 2) 60402mm hot galvanized steel or stainless steel frame 3) 25mm Anti‑skid plastic square 4 ) 304 Stainless steel ladder and handrail
Quotation control	Send the floor plan, operator task, product load, rail height and cleaning method. Platforms also require step, handrail, toe‑board and local fall‑protection details.

Reference configuration transcribed and normalized from the cited HT product page; confirm the final quotation and approved drawing.

Application

The usual application is carcass receiving, trimming, evisceration, offal handling and other staffed positions in an abattoir. It can be specified for a new line or adapted to a retrofit, provided that the existing supports, working heights, utilities and control signals are measured on site. Plants handling several pig sizes should state the full range rather than quoting only an average.

Application Case

Illustrative reference case-A regional pork processor planning for 300 pigs per hour places the pig abattoir working platform between the relevant upstream and downstream stations. Before fabrication, the project team freezes the interface drawing, utility points and operator access. The acceptance check covers dry running, representative‑load operation, emergency stops, cleaning access and a spare‑parts handover.

Advantages

1. Fits into a defined process stage, which makes line balancing and internal linking easier.
2. Project‑specific dimensions reduce awkward field modifications at installation.
3. Service points and replaceable wear parts can be agreed before shipment.
4. Hygiene and drainage requirements can be reviewed with the equipment layout.
5. Reference source data remains visible instead of being converted into unsupported marketing claims.

Pig Abattoir Working Platform FAQ

What information is needed to quote the Pig Abattoir Working Platform?

Send the floor plan, operator task, product load, rail height and cleaning method. Platforms also require step, handrail, toe-board and local fall-protection details.

Can it be connected to an existing slaughter line?

Usually yes, but a retrofit needs measured drawings. Share the rail or conveyor interface, floor levels, travel direction, available space, utilities and current control method before engineering starts.

Which spare parts should be ordered with the machine?

Start with the normal wear and hygiene parts for this duty: bearings, seals, sensors, chains or belts, nozzles, blades, scrapers, pneumatic parts and electrical protection devices as applicable. The supplier should issue a model-specific list.

Are the published technical figures final?

No. The table records reference information from the citedHTpage. Capacity, power, dimensions, material grade and utilities must be confirmed on the quotation and approved drawing.

How should the equipment be accepted after installation?

Use a documented site-acceptance test covering alignment, guards, emergency stops, interlocks, dry running, representative load, cleaning access, leakage or drainage, operator training and delivery of manuals and spares.