Product Overview
This Pig Head Hydraulic Shear is specified for one practical job: a powered cutting tool for controlled separation of the pig head or another heavy carcass joint. A reliable installation begins with correct interface dimensions and a realistic duty cycle. The HT listing supplies reference data for the offered arrangement; those figures are reproduced below for comparison. For export quotations, confirm voltage, materials, guarding, spare parts and documentation before the purchase order is released.
Working Principle
Hydraulic pressure closes the blades through the target joint. The operator positions the tool, initiates the cycle and releases it after the cut; the blade set is then cleaned and sterilized before reuse. The upstream machine must not feed faster than the receiving station can clear.
Main Features
High cutting force with controlled blade travel
Two‑hand or guarded actuation options
Balanced suspension for operator handling
Replaceable blades and seals
Separate sterilization provision
Service access to the hydraulic unit
Technical Specifications
| Parameter | Reference Value / Buyer Check |
| Model | HT‑P405‑I |
| Application | Which main used to cut pig head by hydraulic |
| Rated voltage/Phase/Frequency | 380V/3P/50HZ |
| Power | 3Kw |
| Blade opening size | 300mm |
| Hydraulic pressure | 220bar |
| Compressed air pressure | 6bar |
| Capacity | 4sec/ time |
| Weight | 37KG |
| Component and material | 1) Balance 2) Hydraulic station 3) Connecting soft pipe |
| Quotation control | Confirm cutting location, carcass range, required cycle rate, hydraulic pressure, hose length, suspension and local safety controls. Order spare blades and a seal kit. |
Reference configuration transcribed and normalized from the cited HT product page; confirm the final quotation and approved drawing.
Application
The usual application is head removal and heavy cutting stations on medium‑ and high‑throughput pig dressing lines. It can be specified for a new line or adapted to a retrofit, provided that the existing supports, working heights, utilities and control signals are measured on site. Plants handling several pig sizes should state the full range rather than quoting only an average.
Application Case
Illustrative reference case-A regional pork processor planning for 200 pigs per hour places the pig head hydraulic shear between the relevant upstream and downstream stations. Before fabrication, the project team freezes the interface drawing, utility points and operator access. The acceptance check covers dry running, representative‑load operation, emergency stops, cleaning access and a spare‑parts handover. This is a planning example, not a claim about a named customer installation.
Advantages
1. Fits into a defined process stage, which makes line balancing and internal linking easier.
2. Project‑specific dimensions reduce awkward field modifications at installation.
3. Service points and replaceable wear parts can be agreed before shipment.
4. Hygiene and drainage requirements can be reviewed with the equipment layout.
5. Reference source data remains visible instead of being converted into unsupported marketing claims.
